· Model based on advanced technology.
· Single Operator for Three Operations.
· Rinse – Fill & Seal cycle, fully Trio-block for total filling hygiene. The whole process is automatic.
· Bottle in-feed using high pressure air conveyor with air filter on suction side.
· Less Floor Area.
· No Contamination – as immediate sealing of filled bottles.
· Centralized Volume Adjustment System- no down time in volume settings.
· SS 316 material used for filling valves
· No Bottle –No Fill for Individual head, hence no spillages.
· Torque adjustable capping heads.
· Machine is fully Neck holding by design, so no change part required for different size of bottles.
· Automatic PLC control speed regulation.
· The advanced Programmed Logic Controller (PLC) is adapted to control the machine runs automatically, air conveyor system is adopted in bottle entry section and belt conveyor system is adopted in bottle exit section, which can adjust speeds and coordinated with transducer of the main machine to make the operations of moving bottle forward steadily and reliably.
· In-feed can be linked directly with automatic blow molding machine
· Machine covered with SS 304 frame & Acrylic Doors for total filling hygiene
· Placing of Cap Feeder Outside Trio-block-avoid entering of dust in it.
· Better finish – imported polished, laminated S.S. sheet used.
· Separate variation drive to control speed of conveyor.
· Self-Lubricating UHMW- PE Guide profile for Low friction wear surface, smooth and noiseless conveying.
· Fully automatic rotor to rotor transfer without any human contact. It is convenient to operate with higher automation
· Safety Guard for Operation and Protection.